ProSoft Technology MVI46-GSC - Manual (Page 12)

MVI46-GSC ♦ SLC Platform Start Here
Generic Serial Communication Module
Page 12 of 78 ProSoft Technology, Inc.
December 5, 2007
1.6 Download the Sample Program to the Processor
¾ To download the sample program from RSLogix 500 to the SLC
processor:
Note: The key switch on the front of the SLC processor must be in the REM position.
1 If you are not already online to the processor, open the Communications
menu, and then choose Download. RSLogix will establish communication
with the processor.
2 Click the Download button to transfer the sample program to the processor.
3 RSLogix will compile the program and transfer it to the processor. This
process may take a few minutes.
4 When the download is complete, RSLogix will open another confirmation
dialog box. Click Yes to switch the processor from Program mode to Run
mode.
Note: If you receive an error message during these steps, refer to your RSLogix
documentation to interpret and correct the error.