Replacing the remote batteries, Cleaning, Customer service – Bose Solo 15 Series II User Manual

Page 19: Limited warranty, Technical information, Care and maintenance

Advertising
background image

English - 19

Care and Maintenance

Replacing the remote batteries

Solo 15 series II system remote control

Replace both batteries when the remote control stops operating or

its range seems reduced. Use Alkaline batteries.
1. Slide open the battery compartment cover on the back of

the remote.

2. Remove both batteries.

Dispose of the batteries according to the regulations in

your area.

3. Insert two AA (IEC-LR6) 1.5V batteries or the equivalent. Match

the + and – symbols on the batteries with the + and – markings

inside the compartment.

4. Slide the battery compartment cover back into place.

Solo 10 series II system remote control

Replace the battery when the remote control stops operating or its

range seems reduced. Use a lithium battery.
1. Using a coin, turn the battery cover slightly left.

2. Remove the cover and insert the new battery (CR2032 or

DL2032) flat side up, with the plus (+) symbol in view.

3. Reseat the cover and turn it right to lock into place.

WARNING: Do not ingest battery, chemical burn hazard.

The remote control supplied with this product contains a

coin/button cell battery. If the coin/button cell battery is

swallowed it can cause severe internal burns in just two

hours and can lead to death. Keep new and used batteries

away from children. If the battery compartment does not

close securely, stop using the product and keep it away from

children. If you think the battery may have been swallowed or

placed inside any part of the body, seek immediate medical

attention. The coin/button cell battery may explode or cause

a fire or chemical burn if incorrectly replaced or mishandled.

Do not recharge, disassemble, heat above 212°F (100°C) or

incinerate. Replace only with an agency approved (ex. UL)

CR2032 or DL2032 3-volt lithium battery. Dispose of used

batteries promptly.

Cleaning

• Clean the surface of the system with a soft, dry cloth.
• Do not use any sprays near the system. Do not use any solvents,

chemicals, or cleaning solutions containing alcohol, ammonia or

abrasives.

• Do not allow liquids to spill into any openings.

Customer service

For additional help, contact Bose Customer Service. Refer to the

contact sheet in the carton.

Limited warranty

Your system is covered by a limited warranty. Details of the limited

warranty are provided on the product registration card in the

carton. Please refer to the product registration card for instructions

on how to register. Failure to register will not affect your limited

warranty rights.
The warranty information provided with this product does

not apply in Australia or New Zealand. See our website at

www.bose.com.au/warranty or www.bose.co.nz/warranty for

details of the Australia and New Zealand warranty.

Technical Information

Power rating
100-240V

50/60 Hz 50W

Advertising