Yamaha Reface YC - Manual (Page 48)

42 reface CS/DX/CP/YC Owner’s Manual
Appendix
 Factory Reset
For returning all settings, including keyboard settings, to their factory defaults. On the reface CS and
the reface DX, loop phrases are also restored to the factory default condition.
For details, refer to “Restoring the Factory Default Settings (Factory Reset)” (page 40).
 Display when carried out
 Speaker Output
For setting whether or not to output the instrument’s sound from its built-in speakers. The speakers
will not produce any sound when this parameter is set to “off.”
Factory default setting: ON
 Display when set
 MIDI Control
For turning on and off the transmission and receipt of MIDI Control Change messages specifically for
the reface. When you operate the instrument with this parameter turned on, MIDI messages for your
specific model will be transmitted. No messages are transmitted when you change the volume or
octave. On the reface DX, a MIDI Control Change message is transmitted when a setting is changed in
the FM section ([FREQ], [LEVEL], [ALGO], and [FB] buttons) but not when any other settings are
changed. For more information about the correspondence between controllers, control change num-
bers, and values, refer to the MIDI Reference (a digital manual).
Factory default setting: off
 Display when set
CS The OSC [TYPE] lamps flash.
DX “Factory reset” is displayed on-screen.
CP The TYPE lamps flash.
YC The WAVE lamps flash.
CS
ON: The lamps from the LOOPER section light up.
off: The lamps from the LOOPER section flash.
DX “speakers ON” or “speakers off” is displayed on-screen.
CP
ON: The [TYPE] knob’s Clv lamp and the lamps from the TREMOLO/WAH to D.DELAY/
A.DELAY sections light up.
off: The [TYPE] knob’s Clv lamp and the lamps from the TREMOLO/WAH to D.DELAY/
A.DELAY sections flash.
YC
ON: The ROTARY SPEED lamps light up.
off: The ROTARY SPEED lamps flash.
CS
ON: The lamps from the LOOPER section light up.
off: The lamps from the LOOPER section flash.
DX “MIDI control ON” or “MIDI control off” is displayed on-screen.
CP
ON: The [TYPE] knob’s Clv lamp and the lamps from the TREMOLO/WAH to D.DELAY/
A.DELAY sections light up.
off: The [TYPE] knob’s Clv lamp and the lamps from the TREMOLO/WAH to D.DELAY/
A.DELAY sections flash.
YC
ON: The ROTARY SPEED lamps light up.
off: The ROTARY SPEED lamps flash.