Klipsch RP-140WM - Manual (Page 7)

7
KLIPSCH REFERENCE PREMIERE HD WIRELESS | EXTENDED USER GUIDE V07 | 02.03.2016
ON-SCREEN SETUP GUIDE
LANGUAGE SELECTION
• Select your desired language.
NOTE: You will have the ability to change your language preference at any time from the menu system.
ADD SPEAKERS
• Plug in your HD Wireless speakers if you haven’t already. The LEDs on the front of the speakers will blink when they are
ready to be discovered.
• Your HD Control Center will then begin searching for your speakers that will comprise your system. This process should take
about 1 - 2 minutes. At the end, a notification will appear indicating the number of speakers that were found. If no speakers
were discovered, please try the setup again.
CONFIRM SPEAKER LOCATIONS
• Once your speakers have been discovered, their channel assignments within the system must be confirmed. One by one,
each speaker will play a test tone and flash its front-facing LED to denote which is currently active. You will be asked
where the tone is coming from and select from the list of speakers on screen. The default selection should be the one
corresponding to the one you selected on the Smart Speaker Selector on the speaker’s rear panel.
• If you selected a different location than the default, your HD Control Center will reassign the speaker location and update
the speaker.
NOTE: If conflicts occur, you will be prompted with a warning that multiple speakers are assigned to the same location.
Choose whether to check the speaker locations again or continue with the redundancy.
SETUP COMPLETE
• Your basic setup process is complete. You are now ready to enjoy your system.