Eureka 7600 SERIES - Manual (Page 7)

GENUINE
EUREKA PRODUCT Look for the symbol.
For location of nearest Eureka
Warranty Station or service
information call 1-800-282-2886.
Pull
HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid
unnecessary service calls, check the bag, belt, and brush roll often.
Brush Roll
The brush roll turns to brush and sweep the carpet. Remove hair and threads from the
brush roll so it can continue to brush the carpet. To maintain the most efficient cleaning,
the bristles must touch the carpet. To test the bristle length, hold a ruler against the
underneath side of the cleaner. If the bristles no longer touch the ruler, replace the
brush roll.
Brush Roll Belt
The brush roll belt turns the brush roll as the
bristles sweep and brush the carpet. Check
the belt regularly to be sure it is in good
condition. Replace the belt if it stretches,
cracks or loses tension. Cut away any hair or
threads wound around the brush roll or the
belt pulley because the buildup could cause
the belt to rotate unevenly.
How to Replace Brush Roll Belt
NOTE: Turn off the switch and unplug the
electrical cord before replacing
belt. Belt pulleys can become hot
during normal use. To prevent
injury, avoid touching the motor
pulley when checking the belt.
CAUTION: Improper installation of the
brush roll could cause carpet
or cleaner damage.
Motor
Pulley
Tabs
Slots
Pull
p p p p p
p p p p p
ppppp ppppp
7
1. Turn the cleaner over. Pull up to
remove bottom plate.
2. Lift out brush roll and discard old belt.
3. Fold new belt to slide it around the
motor pulley.
4. Place belt around pulley end of brush
roll.
5. Pull left end of brush roll down to stretch
belt. Align the end cap with the base
and push down to secure.
6. Seat right end cap.
7. Turn the brush roll until the belt centers
onto the brush roll pulley.
8. Slant front of bottom plate
to catch tabs into cleaner
slots. Push down above
each hook to snap into
place.
Use GENUINE EUREKA
replacement belt, 54312.