İhlas Aura MaxiVac - Manual (Page 8)

8
Tighten the filter
securing lock
clockwise.
Make sure that the
tank is empty.
Pull power cable and
insert its plug into the
main power supply.
Press on green buttonfor
power. If machine is on,
the led light will be
illuminated.
Place the head unit and
attach suction hose to
inlet connector.
Insert the handle into
end of the telescopic
tube
Attach suction group. Place the filter slot in the
direction of the arrow.
4
5
11
Place the sponge filter in
the direction of the arrow.
3
12
2
Lift the head unit from
the dirt collection tank.
1
8
5 6 7
In the event of a wet spill in your home, your device can be used to remove liquids from
your floor.
Use the following steps convert your device from sweeping mode to wet vacuuming mode.
Wet spill vacuuming
WARNING
NOW, YOUR DEVICE IS READY TO VACUUM WET SPILLS.
Do not use your device to vacuum any hazardous liquids like flammable liquids,
corrosives, acids, oil based liquids, etc...
WARNING
During the vacuuming, if the water level is exceed in the tank, the noise of the device
will be higher. In that case, unplug your device and discharge the water from the tank.
If needed, attach the rubber
to the big/mini washing
nozzle by sliding tool onto
the front of the head.
10
Attach big/mini washing
nozzle to telescopic tube
and lock it in place.
9