Entering the password – Epson EB 824 User Manual
Page 30
Procedure
A
During projection, hold down the [Freeze] button for about
five seconds.
The Password Protect setting menu is displayed.
Remote Control
q
• If Password Protect is already activated, you must enter the
Password.
If the Password is entered correctly, the Password Protect setting
menu is displayed. s "Entering the Password"
• When the Password is set, stick the Password protect sticker in a
visible position on the projector as a further theft deterrent.
B
Turn on Power On Protect.
(1)
Select Power On Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Return] button.
C
Turn on User's Logo Protect.
(1)
Select User's Logo Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Return] button.
D
Turn on Network Protect.(EB-826W/825/85/84 only)
(1)
Select Network Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Return] button.
E
Set the Password.
(1)
Select Password, and then press the [Enter] button.
(2)
The message Change the password? is displayed, select Yes and then
press the [Enter] button. The default setting for the Password is "0000".
Change this to your own desired Password. If you select No, the screen
shown in step 1 is displayed again.
(3)
While holding down the [Num] button, enter a four digit number using
the numeric buttons. The number entered is displayed as "* * * *". When
you enter the fourth digit, the confirmation screen is displayed.
Remote Control
(4)
Re-enter the Password.
The message Password accepted. is displayed.
If you enter the Password incorrectly, a message is displayed prompting
you to re-enter the password.
Entering the Password
When the Password entry screen is displayed, enter the Password using
the numeric buttons on the Remote Control.
Security Functions
30