Samson Stage 212 Frequency-Agile Dual-Channel Handheld VHF Wireless System (173 to 198 MHz) - Manual (Page 10)

10
Quick Start
In order for your wireless system to work correctly, both the receiver and transmitter must be set to
the same channel.
Follow this basic procedure for setting up and using your Stage 212 wireless system:
Physically place the SR212 receiver where it will be used, and fully extend the antennas
vertically. The general rule of thumb is to maintain “line of sight” between the receiver and
transmitter so that the person using or wearing the transmitter can see the receiver.
With the SR212 powered off, connect the included power adapter. Turn the SR212 on
momentarily to confirm that the unit is receiving power. You’ll see the LED display light up.
Then turn the SR212 power off.
With your amplifier or mixer off and volume control
all the way down, connect the SR212 receiver 1/4”
outputs (or XLR Mix Output) to the inputs of a mixer
or amplifier. Turn the Level knob on the SR212
completely counterclockwise, then turn its power on.