Samson Stage 212 Frequency-Agile Dual-Channel Handheld VHF Wireless System (173 to 198 MHz) - Manual (Page 12)

12
Quick Start
Position the VH212 transmitter about 6-12" (15-30 cm) from the front of the SR212 receiver
with the transmitter's IR window facing the IR transmitter on the front panel of the SR212
receiver.
Press and hold the SR212 CH A SELECT button to set the transmitter to the same channel as
the receiver via infrared transmission
When the transmission is complete, the SR212 will receive RF signal and the tone key from
the transmitter. The CH A READY indicator will light on the front panel of the SR212 receiver.
Repeat these steps for the CH B transmitter and receiver. CH A and CH B available frequency
channels do not overlap, so you can set the two receivers to the same channel number or letter.
Turn on your connected amplifier or mixer, but keep the volume all the way down. Set the
Volume knob on the SR212 fully clockwise (to its “10” setting). This is unity gain.
Speak or sing into the microphone. Slowly raise the volume of your amplifier or mixer until the
desired level is reached.
If you find the system has noticeable dropouts, reduced overall working range, or unexpected
noise bursts, change the operating channel of the system using the steps above.
When using multiple systems in the same frequency band, each system must be set to a different
operating channel.