Samson Airline ALX Wireless UHF Lavalier System (K: 470 to 494 MHz) - Manual (Page 11)

AirLine ATX Wireless System 11
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
ATX Headset Transmitter Callouts
1. Power/Mute Button - Press and hold for 3 seconds to turn the unit on or off. A quick
press and release will mute or unmute the transmitter when the transmitter is on.
2. Status Indicator - This LED displays the operation mode, low battery and recharge
status of the transmitter. The chart below defines the LED colors for each function.
GREEN Normal Operation
AMBER Mute
Flashing RED
Low Battery
Charging
RED Fully Charged
3. Volume +/– Buttons - Press and hold either Volume button to adjust the volume.
Pressing the + or – button increases or decrease the level by one step with each
push of the button. There is a total 9 volume levels. The Status Indicator light will
flash faster for each increased step and slower for each decrease.
4. IR Lens - This window is used to capture the infrared signal sent from the receiver
during the IR SET to channelize the transmitter. The IR Lens is only active for the
first 10 seconds when the transmitter is powered on.
5. Charging Connector - Connect the supplied magnetic charging cable to this sealed,
gold contact charging connector to recharge the internal Lithium Ion battery. The
ATX can be recharged by connecting the cable to a USB connector on a computer
USB port, or any 5-volt DC adapter that has a USB output.
NOTE: The included adapter will charge the ATX faster than a computer USB port.
6. Input Connector - Connect the input device via the mini-XLR connector. The ATX is
supplied with either a lavalier, headset or instrument microphone.
7. Spring Clip - Use this clip to fasten the ATX transmitter to a belt, waist band or
instrument bell.
3
8
1
2
4
5 6
7