Samson Airline ALX Wireless UHF Lavalier System (K: 470 to 494 MHz) - Manual (Page 7)

AirLine ATX Wireless System 7
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Quick Start
In order for your wireless system to work correctly, both the receiver and transmitter
must be set to the same channel. Follow this basic procedure for setting up and using
your AirLine ATX Wireless System:
1. Physically place the CR99 receiver where it will be used, and extend the antennas
vertically. The general rule of thumb is to maintain “line of sight” between the
receiver and transmitter so that the person using or wearing the transmitter can see
the receiver.
2. With the CR99 powered off,
connect the included power
adapter. Turn the CR99 on
momentarily to confirm that the
unit is receiving power. Then turn
the CR99 power off.
3. With your amplifier or mixer off
and volume control all the way
down, connect the CR99 receiver
output jack to the mic or line
level input of a mixer or amplifier
using the balanced XLR output or
unbalanced ¼” line level output.
Turn the Level knob on the CR99
completely counterclockwise, then
turn its power on.
4. Press and hold the GROUP button on the front of
the CR99 receiver to scan for an available channel
within the selected group.
5. Press and hold the CR99 CHANNEL button
to execute an IR Set which synchronizes the
transmitter to the same channel as the receiver via
infrared transmission.