Sony WI-C300 Wireless In-Ear Headphones (Red) User Manual
Page 21
Conn
ec
tio
n
s
a
nd
Op
er
at
ions
To Return to the Factory Setting
21
GB
To Return to the Factory
Setting
1
Turn the unit on while holding down the RESET
and SELECT buttons.
When the unit is turned on, buttons and indicators
flash as follows:
Yellow (1 second)
t
Green (1 second)
t
Red (1
second)
t
The GROUP/POSITION button that
was selected when the unit was turned off last (with
the upper or lower indicator beside of the SHIFT
button and GROUP indicator) and the CAMERA
button (2 seconds)
2
When the GROUP/POSITION and CAMERA
buttons flash in green, release the RESET and
SELECT buttons, then turn the unit off by pressing
the
1
button.
When the unit is turned on next time, the unit will
start with its factory settings.
Factory settings
• IP address of the IP remote controller:
192.168.0.10
• Subnet mask of the IP remote controller:
255.255.255.0
• Default gateway of the IP remote controller:
0.0.0.0
• Name of the IP remote controller: CTL1
• A camera IP address of 192.168.0.100 is assigned
to the camera number 1 of the camera group
number 1. No other IP addresses are assigned to
any of the other camera numbers or camera group
numbers.
• The unit starts with camera number 1 of camera
group number 1 selected.
• LOCK button: The lock function is not activated.