How to assemble attach handle, Attach hose store hose and accessories, Store electrical cord – Eureka 5840-5898 Series User Manual

Page 4

Advertising
background image

CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, make sure on/off switch is in

off (0) position before plugging in.

NOTE: Features may vary by model yet all parts

assemble the same.

HOW TO ASSEMBLE

Attach Handle

CAUTION: Do not catch cord under handle.

1. From rear of cleaner, align handle with groove and slide

onto cleaner. If necessary, use thumb and finger
pressure to slide handle into position.

2. Attach handle with the two 1 inch screws provided in

the assembly packet. Use a Phillips

®

head screwdriver.

NOTE: Hand tighten with screwdriver to be sure both

screws are firmly seated.

Groove

Groove

1

2

1

3. Pick up hose and lay across upper hose retainer.

4. Push the end of the hose in the lower hose retainer to

secure.

4

Lower Hose Retainer

Hose

Upper Hose
Retainer

3

Attach Hose

Store Hose and Accessories

Nested Wands

Dusting
Brush

Store Electrical Cord

4

5. You will find your cord retainer on the handle above the

upper cord hook. Firmly push the electrical cord down
into the cord retainer. This will place the cord out of the
way the next time you vacuum.

6. Next wind the cord around the two cord hooks on the

back side of cleaner.

7. Secure the plug to the cord to prevent unwinding.

Cord Retainer

5

Cord Hook

6

Plug

7

Cord Hook

6

Advertising