Epson 31-396 - Manual (Page 13)

13
7. Thread the ratchet handle (J) Fig. 24, into the tapped
hole (K) and tighten securely.
NOTE: ratchet handle (J) is spring loaded and can be
repositioned by pulling out on the lever and
repositioning it on the serrated nut located
underneath the lever.
Fig. 24
Fig. 25
Fig. 26
Fig. 27
8. Place one of the three rubber sanding drums and
sand paper (L) Fig. 25 on the sanding spindle.
9. Place the 5/16" spindle washer (M) Fig. 26, on a
5/16-18x1/2" hex head screw (N). Thread screw into
tapped hole on end of sanding spindle. Place the rod (P)
into the hole on the side of the spindle to lock the
spindle. Tighten screw securely with the 12mm open
end wrench.
10. Remove the three flat head screws (O) Fig. 27, that
hold the table insert (P) to the sanding table.
11. Remove the 4" table insert (R) Fig. 27, and replace it
with the appropriate table insert.
1-1/2" Drum - 1-1/2" Table Insert
2" Drum - 2" Table Insert
3" Drum - 3" Table Insert
(See Fig. 5)
O
O
O
P
L
J
K
M
N
P