Epson 31-396 - Manual (Page 21)

21
MAINTENANCE
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Make sure that the belt sander is in the horizontal
position as shown in Fig. 55.
Fig. 56
Fig. 57
Fig. 55
2. Remove the two screws (A) Fig. 56, on top of the
gear box cover (G) Fig. 55.
3. Remove the two screws, located right below screws
(A) Fig. 56, on the bottom of the gear box cover. Remove
the gear box cover.
4. Remove the screw (D) Fig. 57, on top of the gear
box.
5. Fill the gear box with machine oil and replace screw
(D) Fig. 57.
6. Replace the gear box cover and screws that were
removed in STEPS 2, 3, AND 4.
LUBRICATION
After the machine has been operated for approximately
500 hours, check oil level.
G
A
D