Asus Republic of Gamers Swift PG279QM 27" 16:9 G-SYNC 240 Hz QHD HDR IPS Gaming Monitor - Manual (Page 20)

3-2 Chapter 3: General Instructions
3.1.2 OSD function introduction
1. G-SYNC ® Processor
MOVE/ENTER BACK EXIT
G-SYNC Mode DisplayPort 2560x1440@240 Hz
HDR Off Racing Mode Analyzer Inactive
ROG Swift 240Hz PG279QM G-SYNC Processor ®
G-SYNC Processor
Gaming
Image
Color
Input Select
Shortcut
Lighting Effect
System Setup
® NVIDIA Reflex Latency Analyzer
• NVIDIA Reflex Latency Analyzer
You need to position the “Monitoring Rectangle” where there is a near
immediate change in luminance. The faster, the better. This is most often the
muzzle flash, but can be a scope change or other instantaneous movement.
This will vary by your game.
Before using this function, follow below steps to finish the monitor setup:
a. Plug in Type-B end of the USB 3.0 cable into the back of the monitor
and plug the other end into your computer.
b. Plug in the Reflex Latency Analyzer supported mouse at the back of the
monitor into the USB port closest to you when facing the display.
c. Ensure the monitor is set to G-SYNC Esports mode .
d. Select On in the G-SYNC ® Processor > NVIDIA Reflex Latency
Analyzer > PC + Display Latency menu.
e. The Reflex Latency Analyzer Monitoring Rectangle will appear in
the center of your screen along with the PC + Display Latency metric
located at the top left corner of the screen.
* PC + Display Latency : Enables or disables the latency analyzer
function. When enabled, the analyzer detects clicks coming from your
mouse and then measures the time it takes for the resulting pixels (i.e.
a gun muzzle flash) to change on screen during gameplay.
* Monitoring Sensitivity : Adjusts the monitoring sensitivity.
* Show Monitoring Rectangle : Displays or hides the monitoring
rectangle. This rectangle specifies which pixels the G-SYNC processor
will sense during a mouse click.
* Monitoring Rectangle Preset : Adjusts the default preset location for
the monitoring rectangle.
* Monitoring Rectangle Location : Manually adjusts the location of the
monitoring rectangle using the ( 5-way) button.