Angler Silverbox Softbox (18") - Manual (Page 6)

Assembling the softbox
1. Insert the small tip of a flex rod through the
guide loop along the seam of the softbox fabric
shell. Insert the tip into the anchoring pocket
at the front end of the softbox. The large tip
at the curved end of the pre-shaped flex rod
should be positioned at the rear of the softbox
fabric shell. Repeat this step with the remaining
flex rods.
2. With the speed ring’s reflector mount facing
away from the softbox, insert the end of a flex
rod into a rod hole in the speed ring.
3. Insert the second flex rod in the softbox fabric
shell into the hole in the speed ring that is
directly opposite the first hole used. Flex the
rod gently but firmly until it is securely seated
in the speed ring.
4. Insert the third and fourth flex rods into the
speed ring in the same manner. As each flex rod
is inserted, flex it gently but firmly into position
until each rod is securely seated in the speed
ring. Continue in the same manner, always
working in opposite pairs.
NOTE: the second pair of flex rods installed should
be at a 90° orientation from the first pair so that a
square framework is established.
1
2
3
4
6