Epson 402169004 - Manual (Page 5)

3
English
Safety Instructions
Follow these safety instructions when setting up and using the projector :
• Do not place the projector on an unstable cart, stand, or table.
• Do not use the projector near water or sources of heat.
• Use attachments only as recommended.
• Use the type of power source indicated on the projector. If you are not sure of
the power available, consult your dealer or local electricity company.
• Place the projector near a wall outlet where the plug can be easily unplugged.
• Insert the projector’s three-pin grounding-type plug into a properly grounded
outlet. If you have a two-prong outlet, contact an electrician to replace it. Do
not handle the plug with wet hands.
• Take the following precautions when handling the plug. Failure to comply with
these precautions could result in sparks or fire.
• Do not insert the plug into an outlet with dust present.
• Insert the plug firmly into the outlet.
• Do not overload wall outlets, extension cables or integral convenience
receptacles. This can cause fire or electric shock.
• Do not place the projector where the cable can be stepped on. It may result in
fraying or damage to the plug.
• Unplug the projector from the wall outlet before cleaning. Use a damp cloth
for cleaning. Do not use liquid or aerosol cleaners.
• Do not block the slots and opening in the projector case. They provide
ventilation and prevent the projector from overheating. Do not place the
projector on a sofa, rug or other soft surface, or in a closed-in cabinet unless
proper ventilation is provided.
• Never push objects of any kind through cabinet slots. Never spill liquid of any
kind into the projector.
• Unplug the projector when it will not be used for extended periods.
• Do not place the projector and remote control on top of heat producing
equipment or in a heated place, such as a car.
• Unplug the projector from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
• When the power cable or plug is damaged or frayed
• If liquid has been spilled into the projector, or it has been exposed to rain or
water
• If it does not operate normally when you follow the operating instructions, or if
it exhibits a distinct change in performance, indicating a need for service
• If it has been dropped or the housing has been damaged