Epson 402169004 - Manual (Page 9)

7
English
• The mercury lamp that is used as the projector's light source deteriorates as
a result of normal use and as a result of impacts or other damage, and may
also break with a loud noise, stop working or reach the end of its service life
more quickly.
At such times, the amount of time remaining before the lamp breaks or stops
working may vary greatly depending on the individual lamp characteristics and
the operating environment. These are normal characteristics of mercury lamps.
You should always have a spare lamp ready in case it is needed.
• EPSON takes no responsibility for loss or damage caused by damage to the
projector or operating failures outside normal service warranty conditions.
Lamp Operating Errors
The mercury lamp that is used as the light source for this projector may stop
operating on occasions. This is a normal characteristic of mercury lamps. If the
lamp does not turn on when the projector's power is turned on, remove the lamp
and check if it is broken. If the lamp is not broken, reinstall it. Refer to the User’s
Guide
for instruction on removing and reinstalling the lamp.
If the lamp is broken replace by a new lamp, or contact your local dealer for further
advise. It is recommended that you have a spare lamp ready at all times in case it is
needed.
Notes on Carrying the Projector
• Turn off the projector power and then disconnect the power cable from the
electrical outlet.
Furthermore, check that all other cables have been disconnected.
• Attach the lens cover to the lens.
• Retract the adjustable foot.
• If your model of projector has a handle, hold the projector by the handle when
carrying it.