Electrolux 55750 - Manual (Page 25)

1
Installation Instructions UK
Any electrical work required to install this
appliance should be carried out by a qualiĆ
fied electrician or competent person.
Any plumbing work required to install this
appliance should be carried out by a qualiĆ
fied plumber or competent person.
• The dishwasher is delivered ready for connection,
i.e. with power supply cable, drain hose and inlet
hose with fitted filter and seal.
• The installation should be carried out to connecĆ
tions provided in a neighboring cupboard (not diĆ
rectly behind the unit).
• The regulations of the local water and electricity
companies must be complied with.
Water Supply Connections
• The dishwasher must be plumbed into a cold water
supply.
• The water pressure must be within the limits given
in the technical specifications. Your local Water AuĆ
thority will advise you on the average mains presĆ
sure in your area.
• A shut-off device with a ¾" connection must be
provided on site.
• The inlet hose has a filter to remove any impurities
from the water supply and a rubber seal. When fitĆ
ting ensure that the filter and seal are correctly poĆ
sitioned.
No water must escape from the fitting after
the shut-off device has been opened.
Water outlet hose connection
• Ensure the drain hose is not bent or squashed as the
could prevent or slow down the discharge of water.
• The outlet hose should be connected to a water
outlet provided in a neighboring cupboard (not diĆ
rectly behind the unit).
• The dishwasher is fitted with a device to prevent the
back flow of water, which allows the installation
height of the unit to be above the outlet height.
• The highest point of the drain hose should never exĆ
ceed the unit height.
153 0409 20 / 09.99
AEG
86 - 91 cm
STOP ECO
ÖKO_FAVORIT
45˚ 45˚ 70˚ 65˚
762
510
574
759
570
550
600
546