Creating arrays – MSI PRO B550-VC AM4 ATX Motherboard User Manual
Page 61
61
AMD RAID Configuration
Creating Arrays
Arrays can be created after the disks are initialized.
⚠
Important
∙
For redundant arrays, the Create process is not started until after the operating
system and AMD-RAID OS drivers have been installed and the system has booted to
the operating system. However, the arrays are immediately available to use for either
a bootable array or a data array.
∙
Array numbers are valid only for a given boot and might be different in the
RAIDXpert2 Configuration Utility and RAIDXpert2. If a permanent label is required, use
the RAIDXpert2 Web GUI Array Naming feature.
∙
At any point in the procedure, return to a prior window by pressing ESC.
∙
If the system is booted from an AMD-RAID bootable array, the first array in the
Arrays section must be the bootable array. The system boots only from the first array
in the Arrays section.
To create an array
1.
As previously mentioned, enable RAIDXpert2 Configuration Utility.
2.
Go to
BIOS > SETTINGS > Advanced > RAIDXpert2 Configuration Utility > Array
Management > Create Array
sub-menu
.
3.
Select the RAID level from the
Select RAID Level
drop down menu.
4.
Enter
Select Physical Disks
sub-menu, select member disks by changing the
Physical Disk setting to
Enabled
.
5.
Select
Apply Changes
, then press Enter to apply and go back to previous sub-
menu.
6.
Change the
Select CacheTagSize
,
Read Cache Policy
and
Write Cache Policy
settings according to your needs.
7.
Select
Create Array
, then press Enter.