CHAUVET DJ GigBAR Move 5-in-1 Lighting System with Moving Heads, Pars, Derbys, Strobe, and Laser Effects (Black) - Manual (Page 29)

Page 23 GigBAR MOVE User Manual Rev. 4
Operation
Master/Slave Mode
The Master/Slave mode allows a single GigBAR MOVE product (the “master”) to control the actions of one
or more GigBAR MOVE products (the “slaves”) without the need of a DMX controller. The master product
will be set to operate in either standalone mode or with the IR remote, while the slave products will be set
to operate in slave mode. Once set and connected, the slave products will operate in unison with the
master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until SLAVE shows on the display.
2. Press <ENTER> .
3. Connect the DMX input of the first slave product to the DMX output of the master product.
4. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
5. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode or with the IR remote.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
• Do not connect more than 7 slaves to the master.