EnGenius Technologies ENH500 - Manual (Page 49)

7.5 WDS Link Settings
WDS Link Settings is used to establish a connection between Access Points without forgoing
Access Point functionality. APs with WDS functionality can extend the wireless coverage and
allow LANs to communicate with each other.
MAC Address Enter the Access Point’s MAC address that you would like to
extend the wireless coverage of into the MAC address filter.
Mode Select Disable or Enable from the drop down list.
Accept / Cancel Press Accept to confirm the changes or Cancel to return
previous settings.
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 4.1 for more information.
The MAC address of the AP that you would like to extend the wireless coverage
of must be entered. Not all Access Points supports this feature.