EnGenius Technologies ENH500 User Manual
Page 71
11 Network Configuration Examples
This chapter describes the role of the ENH500 with 4 modes. The Access Point mode’s default
configuration is a central unit of the wireless network or as a root device of the wired
environment. Repeater Mode and Mesh Network Mode need additional configuration.
11.1 Access Point
Access Point
Step 1
Login to the web-based configuration interface with default IP
192.168.1.1
Step 2
Select your country or region’s regulation.
Step 3
Use site survey to scan channels of the nearby area.
Step 4
Select a channel with less interference.
Step 5
Specify the SSID for your broadcast SSID and you can also
configure multiple SSID at the same time.
Step 6
Verify VLAN identifier in order to separate services among clients
Step 7
Setup the authentication settings.
Step 8
Select Apply to process all of the configurations.
For more advanced settings, please refer to the previous chapters.
Wireless Client
Step 1
Select the Wireless Mode you would like to associate with.
Step 2
Use Site Survey to scan for nearby Access Points and select the
AP that you would like to connect with or enter the SSID
manually.
Step 3
Configure VLAN ID in your wireless device if available.
Step 4
Select the correct authentication type and password.
The ENH500’s Access Point Mode does not provide a DHCP server so the
Wireless Client IP address must be configured manually in Local Area Network Settings.
ENH500
Client
Client
SSID2
SSID1
Ethernet
Client
192.168.1.1
192.168.1.10
192.168.1.11
192.168.1.12