Operating instructions – Enviro 2100 Freestanding User Manual

Page 5

Advertising
background image

CHIMNEY OR RUN AWAY FIRE:
1.
Call local fire department (or dial 911)
2. Close the draft fully
3. Examine flue pipes, chimney, attic, and roof of the house, to see if any part has become hot enough

to catch fire. If necessary spray with fire extinguisher or water from the garden hose.

4. Do not operate the stove again until you are certain the chimney and its lining have not been

damaged.
MAINTENANCE:
At the end of each heating season clean the chimney and the smoke pipe. If soot has accumulated above

the top baffle bricks, remove, clean, and then replace them. If the secondary air tube is badly eroded,

replace it. Replace worn door gaskets and broken bricks as needed.

FAILURE TO INSPECT AND CLEAN YOUR CHIMNEY SYSTEM REGULARLY CAN RESULT IN A

CHIMNEY FIRE, WHICH COULD DAMAGE THE CHIMNEY OR CAUSE A HOUSE FIRE.

B

UILDING

Y

OUR

F

IRE

:

Proper operation of your stove will help to ensure safe, efficient heating. Please take a few moments to

review these simple operating procedures.

1. Fuel Selection:
This stove is designed to burn natural wood only. Higher efficiencies and lower emissions generally

result when burning air-dried seasoned hardwoods, as compared to softwoods or to green or freshly cut

hardwoods. DO NOT BURN the following: treated wood, coal, garbage, solvents, colored papers, or trash.

Burning these may result in the release of toxic fumes and may poison or render the catalytic ineffective.

Burning coal, cardboard, or loose paper can produce soot, or large flakes of char or fly ash that can coat

the combustor, causing smoke spillage into the room, and rendering the combustor ineffective.

2. Building/Maintaining a Fire:
a) Open the primary air slide by pulling it all the way to the right.
b) Place a base of crumpled uncolored newspaper in the bottom of the stove. Lay pieces of kindling on

top of the newspaper and light it.

CAUTION: “Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid,

or similar liquids to start or “freshen up” a fire in this heater. Keep all such liquids well

away from heater while it is in use.

c) As the kindling begins to burn, add several larger pieces of wood until the fire is burning well. At this

point, regular size logs may be added.

NOTE: Until the fire is burning well, leave the draft controls fully open.
d) Regulate the heat output of the stove by adjusting the draft controls to allow a larger fire and vice

versa. A short period of experimentation with the control settings will allow you to regulate the heat

output to keep your home comfortable.

Do not use a grate or elevate the fire. Build wood fire on the stove firebox hearth floor.

Operating Instructions

5

Advertising