Eureka 8860-8899 - Manual (Page 5)

E
N
G
L
IS
H
3 Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com
Handle must be in upright position to ensure that brush roll is lifted off the floor.
Make sure brush roll switch in OFF (O) position before using accessories.
Replace hose end into duster chamber after using accessories.
Dusting Brush
Furniture, drapes, blinds, bookshelves,
lampshades and vents.
1) Remove hose from hose retainer
from back of vacuum.
2) Place dusting brush on end of hose,
wand or crevice tool.
Telescopic Self-Cleaning Duster (on some models)
Use for furniture, blinds, pictures and high-reach areas. Can be used in short or extended positions.
Combination Crevice Tool
and Extension Wand
Baseboards, corners & between cushions
1) Grasp crevice tool near ridges and
pull apart.
2) Turn ridge end to center.
3) Push crevice tool into wand and place
on end of hose.
!
How to Use Accessories
1) Activate static charge: Push power
switch ( I ) on and turn activation knob
for 10 seconds to clean or charge duster.
2) Turn vacuum off and remove duster
from cleaning chamber.
3) Short position: Dust low surfaces.
4) Extended position: Turn twist tabs
to extend. Push firmly to collapse
and turn to lock.
Turbo Nozzle and Stair Hose
(with some models or available for purchase)
Use for furniture and stairs.
Make sure vacuum is below you,
pushed against the bottom step.
1) If model has additional stair hose, attach
to end of wand.
2) Attach turbo nozzle to the end of wand
or hose.
NOTE: Hose length can be increased by
releasing the hose from the hose retainer
on back of unit. Reposition hose inside
hose retainer after using accessories.