Epson 1240U - Manual (Page 51)

46
Using the Transparency Unit
4. Place the transparency unit on the
document table glass so that the hinges
face the rear of the scanner and it fits on
the document table glass.
5. Connect the transparency unit connector
(the arrow on the connector faces up) to
the scanner’s option interface.
6. Turn on the transparency unit.
7. Connect the scanner to a power source.
For information on loading transparencies and selecting driver settings, see the
following sections.
Loading Transparencies
Before scanning transparencies, wipe the lid of
the transparency unit, the scanner’s document
table glass, and the narrow calibration window
near the hinges; dust in the calibration
window can cause a line in the scanned image.
Keep the window uncovered when loading
your transparencies. If your transparency
obstructs the window, the colors in your scans
will be affected.
make sure the
calibration window is
clean and uncovered
lid
basics.book Page 46 Tuesday, October 24, 2000 9:53 AM