Eiki LC-SX6A - Manual (Page 20)

20
Installation
Connecting AC Power Cord
This projector uses nominal input voltages of 120 V or 200-240 V
AC. This projector automatically selects correct input voltage. It is
designed to work with single-phase power systems having a
grounded neutral conductor. To reduce risk of electrical shock, do
not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of type of the power being supplied.
Connect the projector with all peripheral equipment before turning
it on. (Refer to pages 22 ~ 24 for connection.)
Connect the AC power cord (supplied)
to this socket. The AC outlet must be
near this equipment and must be
easily accessible.
Main On/Off switch
AC power socket
CAUTION
For safety, unplug the AC power cord when the projector is not
in use. When this projector is connected to an outlet with the
AC power cord and the Main On/Off switch is on, it is in stand-
by mode and consumes a little electric power.
To the POWER CORD
CONNECTOR on the
projector.
Projector side AC Outlet side
Ground
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the projector.
Confirm the AC plug type with the chart below. The proper AC Power Cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
To the AC Outlet.
(120 V AC)
For Continental Europe For the U.S.A. and Canada
To the AC Outlet.
(200 - 240 V AC)