Polk Audio MagniFi Mini AX 2.1-Channel Dolby Atmos Soundbar System - Manual (Page 23)

21
Engl
ish
My remote control isn’t working.
• Get closer to the sound bar and aim the remote at the front of the sound bar.
• Make sure nothing is blocking the IR receiver on your TV (the part of your TV where
you aim the remote).
• Make sure the batteries are installed in the correct direction.
• Install fresh batteries in the remote.
• To teach your TV, cable, or satellite remote to control the sound bar, see “Use your TV
remote to control the sound bar” on page 18.
How do I perform a factory reset?
Note: A reset will erase all sound bar settings, including Bluetooth and Wi-Fi settings.
With the sound bar turned on, press and hold the Power button ( ) and the Mute
button ( ) on the top panel of the sound bar for 7 seconds. You will hear a chime, then
numbers will countdown on the display, followed by “RESET.” The bar restarts when the
process is complete.
How do I wirelessly connect (pair) my subwoofer or surround speakers?
1. Plug in your subwoofer and/or surround speakers and make sure the sound bar is
powered on.
2. Enter pairing mode on the sound bar by pressing and holding the CONNECT button
on the back panel of the sound bar for about 3 seconds. You will hear a confirmation
tone.
3. On the subwoofer or surround speaker, press the CONNECT button on the back panel
for about 3 seconds until you hear a confirmation tone.
4. Repeat step 3 for other speakers that need to be paired.
5. When finished, press the CONNECT button on the sound bar to save the new pairings
and exit pairing mode.