Electrolux 65080 Vi - Manual (Page 23)

23
In daily use
Setting the Delay Timer
3
With the delay timer you can delay the start of a dishwashing cycle for between
1 and 19 hours.
1. Press the Delay Timer button repeatedly until the multi display shows the de
sired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay
Timer indicator is illuminated.
2. Select dishwashing cycle.
3. The time remaining to the start of the cycle is continuously displayed (e. g. 12h,
11h, 10h, … 1h etc.).
To change the time delay:
As long as the cycle has not yet started, you can still change the setting by
pressing the DELAY TIMER button.
Cancelling the time delay:
Press the Delay Timer button repeatedly until the length of the selected cycle
appears in the multi display. The selected dishwashing cycle will begin immedi
ately.
To change a dishwashing cycle
As long as the cycle has not yet started, you can still change the dishwashing
cycle. First cancel the dishwashing cycle, then re set the time delay, lastly select
the new dishwashing cycle.
Switching Off the dishwasher
When the dishwasher cycle has ended, the dot shaped light signal below the
door of the appliance goes out.
If the acoustic signal has been enabled, a continuous tone will sound for 15 sec
onds at the end of the dishwashing cycle.
If the dishwasher door is not opened, the acoustic signal sounds again after 3
and 6 minutes.
1
Carefully open the door. Hot steam may escape.
• Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for about
15 minutes before removing them. You also get a better drying result.
• Dishes dry more quickly if you open the door for a moment after the cycle has
ended and then leave it slightly open.
1. Press the ON/OFF button. All display indicators will go out.
2. Turn off the water tap.