Electrolux 65080 Vi - Manual (Page 33)

33
Connecting the dishwasher
Dishwashers That Can be Integrated
(see installation template supplied)
Using the installation template supplied, split cupboard doors can be easily in
stalled and firmly fitted.
Connecting the dishwasher
Connecting to the water supply
• The dishwasher can be connected to cold or hot water supplies up to max.
60°C.
• The dishwasher must not be connected to open hot water appliances or in
stantaneous water heaters.
Permitted water pressure
Connecting the inlet hose
1
The water inlet hose must not be kinked, crushed or entangled when it is being
connected.
Connect the threaded hose fitting (ISO 228 1:2000) on the water inlet hose to a
tap with an external thread (¾ inch). The inlet hose is fitted with either a plastic
or a metal nut:
– Only tighten the nut hand tight.
Then do a visual check for water tightness. (Make sure that the tap is not drip
ping.)
3
So that access to the tap in the kitchen is not restricted by the use of the dish
washer, we recommend installing an additional tap, or fitting a T branch to the
existing tap.
Lowest permitted water pressure:
0,1 MPa ( = 1 bar = 10 N/cm
2
)
Consult your plumber if the water pressure is
less than 0,1 MPa
Highest permitted water pressure:
1 MPa ( = 10 bar = 100 N/cm
2
)
If the water pressure is greater than
1 MPa, a pressure reduction valve must be used
(available from your dealer).