Elite Bluetooth VR500CS-BT - Manual (Page 12)

12
Basic Operation
1. TURNING THE UNIT ON / OFF
Press any Button to turn the unit ON. On
the Faceplate, press and hold the POWER
button for 2 seconds to turn the unit off. On
the Remote Control press the Power button
to turn the unit ON & OFF.
2. MODE BUTTON
On the faceplate or remote control press
the Mode button.
TUNER > CD > SD/MMC
* > USB
*
> AUX
> TUNER
* available only if there is media device in
SD/MMC, USB slot.
3. SEL BUTTON
There are 2 menus available through the
SEL button, the Audio Characteristics menu
and the Function menu.
Audio Characteristics
Press the SEL button once to enter the
Select Audio Characteristics Menu, each
press of the SEL button changes the audio
characteristic to be adjusted as follows.
VOLUME > BASS > TREBEL > BALANCE >
FADER > EXIT Menu
Use the Volume + / - buttons to adjust each
Characteristic.
If you have selected a pre-set EQ setting,
then the Bass and Treble chracteristics will
not appear in the SEL menu.
Mute Control
On the faceplate press the Power button to
mute the sound level. Press the Power But-
ton again to cancel.
On the remote control press the
/CAN-
CEL/MUTE button to mute the sound level.
Press the
/CANCEL/MUTE button again
to cancel.
If the unit is muted and you receive a phone
call, the unit will automatically unmute itself
when you answer the phone call.
Loudness Control
On the faceplate or remote control press
and hold the SEL button. Then press the
SEL button 6 times and LOUD will appear
on the LCD. Use the + button or - button to
turn Loudness ON & OFF.
Subwoofer Control
Press and hold the # / BAND button for 2
seconds and SW will appear on the LCD to
indicate the sub woofer output is ON. SW
will disappear from the LCD to indicate the
sub woofer output is OFF.
Dsp
Press and hold the SEL button for 2 sec-
onds, then press the + or - button on the
faceplate, or the VOL+ or VOL - button on
the remote control to cycle through the EQ
pre-sets.
None > Classic > Rock > Pop > Flat
Function Menu
Press and hold the SEL button to enter the
Select Function menu, each press of the
SEL button changes the function to be ad-
justed as follows.
INVOL > AM(12:00) > TAVOL > REC >TEL-
VOL > DSP > LOUD OFF > LOC OFF >Exit
Menu
Use the Volume + / - buttons to adjust each
Function.
Invol
Sets the volume level for the unit when it’s
turned on.
AM(12:00) (Current Time)
Use the volume +/- buttons to set the time.
The volume + button adjusts the hour.
The Volume - button adjusts the minutes.
Tavol
Adjusts the volume Level of the Traffic An-
noucement.
Rec
Press volume +/- buttons to select the re-
cording mode MP3-> WMA (note: when
USB 1.1 recording select WMA format)