Elite Bluetooth VR500CS-BT - Manual (Page 21)

21
1. RCA OUTPUT
The RCA Output Jacks are on the back of
the unit. (Refer to Wiring Diagram) This out-
put is for connecting an amplifier, equalizer,
or other audio componement that requires
a pre-amp out connection. (Red = Right,
White = Left) Follow the manufacturers in-
structions for the audio component that you
are connecting.
2. SUB WOOFER OUTPUT
The Sub Woofer Output Jack is on the back
of the unit. (Refer to Wiring Diagram) This
output is for connecting an amplifier, that
requires a pre-amp out connection.
To use the Subwoofer Out Jack press #/
BAND Button on the front panel, or press
the #/BAND Button on the remote control to
turn the Sub Woofer Jack ON or OFF.
The unit must have an external amplifier in-
stalled to drive the subwoofer.
Follow the manufacturers instructions for
the audio component that you are connect-
ing.
ID3 TAG & SCROLLING MODES
If an MP3 or WMA file has ID3 Tag informa-
tion, it will be displayed on the LCD. ID3 in-
formation varies from file to file. If there is
no ID3 Tag information, nothing will shown
on LCD.
MAINTENANCE
CLEANING THE UNIT
Do not use any liquids to clean this unit.
Do not use petroleum distillates to clean
this unit.
Use a clean, dry cloth to clean this unit.
REPLACING THE FUSE
Make sure the amperage matches the spec-
ified value when replacing the fuse(s). If the
fuse is bad, check the power connection
and replace the fuse with a new one. If the
same problem occurs, this might indicate a
malfunction within the unit.
WARNING
When replacing a fuse, do not use a fuse
with a higher amperage rating than the fuse
originally supplied with your unit, otherwise
damage will result to your unit.
RCA Out, SUB Out & ID3 Tag