Eicon Networks DIVA LAN ISDN - Manual (Page 189)

Appendix C: Command Line Reference Logging and Mail Trace 189
Logging and Mail Trace
SET LOG FILTER {TRACE | DEBUG | INFO | SECURITY | WARNING}
Valid context: General
Specifies the type of information that will be written to the DIVA LAN ISDN Modem event log. See SHOW
LOG for a description of the information written to the log by each setting.
ENABLE LOG MODULE taskName | ALL
DISABLE LOG MODULE taskName | ALL
Valid context: General
Enables or disables the inclusion of firmware module messages in the log file. Each firmware module issues
status messages during the course of its operations. Use this command to set which messages are displayed
from the log when you issue the SHOW LOG command.
taskName: Use module names as shown in SHOW LOG. For example: DHCP, DNS, PPP, IP, IPPP.
ALL: Affects all module messages.
ENABLE LOG OUTPUT SCREEN | REMOTE hostAddr
DISABLE LOG OUTPUT SCREEN | REMOTE
Valid context: General
Sends event log information to the specified device.
SCREEN: Every time an event is added to the log it is also displayed on the local screen.
REMOTE: Every time an event occurs, a message is sent to the remote device.
hostAddr: IP address of the remote device.
SHOW MAIL TRACE [control]
Valid context: General
Displays a mail trace.
control: [buf_size[,entry_size[,filter]]] -p -s -r
buf_size: Size of trace buffer in bytes. (hexadecimal)
entry_size: Maximum size of each element to include.
filter: Type of filter.
- p: Stop/pause trace.
- s: Restart trace from paused state.
- r: Reset (clear) trace buffer.
nothing: auto-pause the mail trace and read current contents
STOP MAIL TRACE
Valid context: General
Stops an active mail trace.
SHOW LOG [STATUS]
Valid context: General
Displays the event log. If STATUS is specified, this command only displays status information.