Whirlpool 27 Inch Ventless Electric Dryer Installation Instructions - Manual (Page 10)

10
1.
Prepare to connect neutral ground
wire and neutral wire
E
B
A
2.
Connect neutral ground wire and
neutral wire
C
E
B
Remove center terminal block screw (B). Remove neutral
ground wire (E) from green external ground conductor screw (A).
Connect neutral ground wire (E) and neutral wire (white or
center) (C) of power supply cord under center terminal block
screw (B). Tighten screw.
3.
Connect ground wire
F
A
Connect ground wire (F) (green or bare) of power supply cord
under green external ground conductor screw (A). Tighten
screw.
3-wire receptacle
(NEMA type 10-30R)
3 prong plug
Spade terminals with
upturned ends
Ring terminals
4.
Connect remaining wires
1.
Remove center screw
B
Connect remaining wires under outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw. Now, go to “Connect Outlet Hose.”
Remove center terminal block screw (B).
3-Wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.