Whirlpool 27 Inch Ventless Electric Dryer Installation Instructions - Manual (Page 16)

16
COMPLETE INSTALLATION
CHECKLIST
Ɨ Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
Ɨ Check that dryer is level. See “Level Dryer.”
Ɨ Check that you have all of your tools.
Ɨ Dispose of/recycle all packaging materials.
Ɨ Check dryer’s final location.
Ɨ Remove film on console and any tape remaining on dryer.
Ɨ Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
Ɨ Read “Dryer Use” in your Use and Care Guide.
Ɨ For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.
Ɨ Select a Timed Dry heated cycle and start dryer.
If dryer will not start, check the following:
• Controls are set to a running or On position.
• Start button has been pressed firmly.
• Dryer is plugged into an outlet and/or electrical
supply.
• Household fuse is intact and tight or circuit breaker
has not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE: You may notice an odor when dryer is first heated.
This odor is common when heating element is first used.
The odor will go away.
#2 Phillips screwdriver Min. 8" (203 mm) long
TORX ® , T20 ® and T25 ® †
screwdrivers
Tools needed:
† ® TORX, T20, and T25 are registered trademarks of Acument Intellectual Properties, LLC.
DOOR REVERSAL (OPTIONAL)
The following instructions are for models with round doors.
1.
Disconnect wiring from door
Using a Phillips screwdriver, remove middle screw in hinge.
Disconnect wiring. Tuck wiring into opening.
DOORS WITH LCD SCREEN: