Eclipse - Fujitsu Ten CD2000 - Manual (Page 10)

- 10 -
English
E
spañol
Français
Italiano
Nederlands
Svenska
English
Installing the main unit Installing the main unit
30˚ or less
Level (reference)
Front
- Installation angle -
To maintain proper function, the main unit must be
mounted less than 30 degrees. If the angle is in
excess of 30 degrees, CD skipping or ejection may
occur.
Tip
Insert the mounting sleeve into the opening in the
vehicle dashboard or console box. 1
Use a screwdriver or a similar tool to bend the
tabs in the mounting sleeve to secure the
mounting sleeve. 2
- Mounting the main unit (If installing the main unit using the mounting sleeve) -
• • Carefully bind any excess length of wire that
is connected to the main unit and secure it
to an area of empty space in the vehicle so
that it does not dislodge or interfere with the
main unit or vehicle-side equipment. If the
wires are not handled correctly, operating
problems or short-circuits may occur, and
this may result in the danger of fire or other
accidents.
• • Connect all wires before installing the main
unit.
Tip
Bend the mounting
tabs.
Dashboard or
console box
Mounting sleeve 3
3 Attach the side brackets to the main unit using
the supplied flathead screws.
Be sure to use the supplied accessory mounting
screws (Red:M5 x 8) as the mounting screws. If
any other screws are used, they may damage the
inside of the main unit.
Tip
Side brackets
Flat head screws
(Red:M5 x 8)
x 2
Main unit 1
4
7