Eiki LC-XT1 - Manual (Page 45)

LC-XT1
.
Follow these steps to replace the lamp assembly.
1
Check the number of lamp to be replaced on Lamp Status
Display.
2
Turn off the projector and disconnect the AC Power Cord. Allow
the projector to cool down for at least 45 minutes.
3
Remove the two screws on the Lamp Cover and press the
button to open the Lamp Cover. (See right figure.)
4
Loosen the two screws and pull out the Lamp Assembly to be
replaced by grasping the handle.
5
Replace the Lamp Assembly with a new one and tighten the two
screws. Make sure the Lamp is set properly
6
Replace the Lamp Cover and tighten the two screws.
7
Connect the AC Power Cord to the projector and turn the
projector on.
8
Reset the Lamp Replacement Monitor Timer. (Refer to the
section “Lamp Replacement Monitor Timer” on page 41.)
NOTE: Do not reset the LAMP REPLACEMENT MONITOR TIMER
when the lamp is not replaced.
CAUTION : Do not operate the projector while any of lamps is removed.
It may result in malfunctions, fire hazard, or other
accidents.