Euro-Pro S3305H - Manual (Page 5)

OPERATING INSTRUCTIONS GETTING TO KNOW YOUR STEAM MOP
1. Hand Grip
2. Power Cord
3. 2-Piece Ergonomic Handle
4. Filling Cap
5. Main Unit
6. On/Off Button
7. Power “On” Light (Green)
8. Empty Light (Red)
Care & Maintenance
9. Tube Pivot
10. Cord Holder
11. Micro-Fiber Cleaning Cloth (x2)
12. Floor Bonnet (Optional)
13. Filling Flask
14. Floor Protector Pad
15. Handle Joint
Technical Specifications
Voltage: 120V., 60Hz.
Power: 800 Watts
Water Capacity: 8 U.S. Fl. Oz.(250ml)
3
Note: Illustrations may differ from actual unit.
1. Turn the unit off and unplug from
electrical outlet.
2. Wrap power cord around cord
holders.
3. Let the unit cool for five (5) minutes
before removing the micro-fiber
cleaning cloth or bonnet (optional)
and before emptying the water tank.
4. Always empty the water tank when
you have finished using the unit.
5. Never leave the micro-fiber cleaning
cloth or bonnet (optional) on the unit
when you have finished using the
steam mop. Always remove the
micro-fiber cleaning cloth or bonnet
(optional) and wash in warm water
with a mild detergent. Never use
bleach or fabric softener when
cleaning the micro-fiber cleaning
cloth. The micro-fiber cleaning cloth
or bonnet (optional) can be washed
in a washing machine and dried in a
clothes dryer but on low heat. We
recommend that you air dry for 24
hours but it could also be dried in a
clothes dryer on a low heat setting.
6. Wipe the unit with a damp cloth to
clean. Never immerse main unit in
water or any other liquid.
7. In order to keep your steam mop in
good condition, we recommend that
you clean the water tank once a
month to eliminate calcium deposits.
Add three ounces (3 oz) of water to
the water tank and shake to loosen
any deposits. Remove the filling cap
and immediately empty water into a
sink. Do not use vinegar or other
decalcifying substances in the
steam mop water tank.
Caution: Do not immerse the unit in
water or any other liquids.
IMPORTANT: Always insure that the
unit is “UNPLUGGED” from the wall
receptacle prior cleaning or before
emptying the water tank.
1. Always vacuum or sweep before
steam cleaning.
2. The easiest way to use the
machine is to tilt the ergonomic
handle to a 45° angle and clean
slowly 2-3 yards at a time.
3. Hand wash or machine wash the
micro-fiber cleaning cloths or
bonnet (optional) in a delicate cycle
with a mild detergent.
4. We recommend air drying the
micro-fiber cleaning cloths or
bonnet (optional) for 24 hours, but
they could be dried in a dryer on a
low heat setting.
5. A good amount of steam passes
through the micro-fiber cleaning
cloth. We recommend that the
cleaning cloth be changed when it
gets too wet. These need to be
replaced as necessary.
6. To remove stubborn stains from
vinyl or linoleum floors, pre-treat
with a mild detergent and some
water before using the steam mop.
IMPORTANT:
Never leave the steam mop in one
spot for any period of time. Always
place the appliance on the floor
protector pad and make sure that
the appliance is turned off.
Helpful Hints
6