Ericsson HM121dp - Manual (Page 43)

Important Information
EN/LZT 108 6429 R1 43 (47)
May 2003
8.3.2.2.2 FCC Part 68
The Federal Communications Commission (FCC) has established Rules which permit
this device to be directly connected to the telephone network. Standardized jacks are
used for these connections. This equipment should not be used on party lines or coin
phones.
If this device is malfunctioning, it may also be causing harm to the telephone network;
this device should be disconnected until the source of the problem can be determined
and until repair has been made. If this is not done, the telephone company may
temporarily disconnect service.
The telephone company may make changes in its technical operations and procedures;
if such changes affect the compatibility or use of this device, the telephone company
is required to give adequate notice of the changes. You will be advised of your right to
file a complaint with the FCC.
If the telephone company requests information on what equipment is connected to
their lines, inform them of:
•
The telephone number to which this unit is connected.
•
The USOC jack required.
•
The FCC Registration Number (indicated on the label).
The Ringer Equivalence Number (REN). Note that if several devices are connected on
the same line, the RENs must not add up to more than 5.0. This REN figure is
important to your telco and can be found on the equipment's FCC compliance label.
In case of operational problems, disconnect your unit by removing the modular or
multi-connector plug from the telco's jack. If your regular phone still works properly,
your modem has a problem and must remain disconnected and (officially) serviced or
returned for repairs. If upon the above disconnection your regular phone still has
problems, notify your telco that they may have a problem. If problem is still found in
premises wiring not telco-installed, you are subject to a service charge. If a fault is
found in telco-installed wiring, you may still be subject to a service call charge.
Unless otherwise noted in the User's Manual (e.g. fuses, etc), user may not under any
circumstances (in our out of warranty) attempt any service adjustment, or repairs on
this unit. It must be returned to the factory or authorized U.S. service agency for all
such work. Locations and phone number orf factory or authorized U.S. service points
are as following:
Company: ASKEY International Corp.
Address: 1751 Yeager Ave, La Verne, CA 91750, USA
Tel: 909-596-5180
8.3.3 Caution
Changes or modifications to this product not autorized by te manufacturer could void
your authority to operate the equipment and invalidate approvals.
8.3.4 Environmental Information
Maximum environmental values during use:
•
Temperature: 0oC to +40oC
•
Humidity: 5% to 85% RH, non-condensing.