Hestan 48 Inch Freestanding Dual Fuel Range Use and Care Manual - Manual (Page 17)

© 2019 Hestan Commercial Corporation
15
EN
GETTING STARTED WITH YOUR APPLIANCE
(CONTINUED)
SEALED BURNERS
Ensure the sealed burner heads are properly installed and seated on the burner base as shown below.
There are notches on the burner base and cross ring to help with alignment. The outer burner head
features a long slot on the top of the head which aligns with the spark igniter. Assembly of the
single-flow burner head is similar.
FIRST TIME OPERATION
Ensure there are no packaging materials inside the oven. Remove any labels or plastic film from the
outside of the appliance. Before using your oven for the first time, it will be necessary to run a bake
cycle to burn off any manufacturing oils and residues from the oven cavity. This may produce a little
smoke and some odor. This is normal and is typical of any new oven when first used. If the smell
is strong, remove persons and animals from the kitchen during this period. Open any windows to
further vent the odor from the room.
Install all the oven racks. Turn on your vent hood, and run the oven on BAKE at 500°F [260°C] for
1-1/2 hours. Allow to cool completely before attempting to cook.
DUAL-OVEN MODELS
For dual-oven models, perform the same first-time process on the companion oven. This can be done
at the same time as the main oven.
BURNER
RING
BURNER
HEAD
BURNER
BASE
IGNITER
INNER
BURNER
HEAD
OUTER
BURNER
HEAD
BEAUTY
RING
CROSS
RING
BURNER
BASE
DUAL FLOW
BURNER
SINGLE FLOW
BURNER