Epson Apex 20020 - Manual (Page 24)

3. Connect the monitor cable to the video card connector on
the back of the computer, as shown below. If the plug has
retaining screws, tighten them securely.
4. If necessary, plug the monitor’s power cord into the
monitor’s power inlet. (The power cord on Apex monitors
is already attached.)
5. Plug the other end of the monitor’s power cord into an
electrical outlet.
Note Note
If the monitor has the proper type of plug, you can plug If the monitor has the proper type of plug, you can plug
it into the auxiliary AC outlet next to the AC inlet on it into the auxiliary AC outlet next to the AC inlet on
the back of the computer. the back of the computer.
6. If you connected the monitor to the MGA card in the
computer, set the color/mono monitor switch on the card
(shown in the following illustration) to match the type of
monitor you are using, either color or monochrome.