Epson Apex 20020 - Manual (Page 6)

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This equipment generates and uses radio frequency energy and if not installed and
used properly, that is, in strict accordance with the manufacturer’s instructions, may
cause interference to radio and television reception. It has been type tested and
found to comply with the limits for a Class B computing device in accordance with
the specifications in Subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, you are
encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient the receiving antenna
•
Relocate the computer with respect to the receiver
•
Move the computer away from the receiver
•
Plug the computer into a different
outlet
so that the computer and receiver are
on different branch circuits.
If necessary, consult your dealer or an experienced radio/television technician for
additional suggestions. You may find the following booklet prepared by the Federal
Communications Commission helpful:
“Television Interference Handbook.”
This booklet is available from the U.S. Government Printing Office, Washington,
DC 20402. Stock No. 004-000-00450-7.
Note: If the interference stops, it was probably caused by the computer or its
peripheral devices. To further isolate the problem: Disconnect the peripheral devices
and their input/output cables one at a time. If the interference stops, it is caused by
either the peripheral device or its I/O cable. These devices usually require shielded
I/O cables. For Epson peripheral devices, you can obtain the proper shielded cable
from
your
dealer. For non-Epson peripheral devices contact the manufacturer or
dealer for assistance.
WARNING: This equipment has been certified to comply with the limits for a
Class B computing device, pursuant to Subpart J of Part
15 of FCC Rules. Only
peripherals (computer input/output devices, terminals, printers, etc.) certified to
comply with the Class B limits may be attached to this computer. Operation with
non-certified peripherals is likely to result in interference to radio and TV
reception. The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and may cause
interference levels that exceed the limits established by the FCC for this
equipment.
This digital apparatus does not exceed the Class A/ Class B (whichever is applicable)
limits for radio noise emissions from digital apparatus as set out in the radio
interference regulations of the Canadian Department of Communications.
Le present appareil numérique n’émet pas de bruits radioelectriques dépassant les
limites applicables aux appareils numériques de Classe A/de Classe B (selon le cas)
prescrites dans le règlement sur le brouillage radioelectriques édicté par le Ministère
des Communications du Canada.
i i i