Gaggenau 400 Series 36 Inch Induction Smart Cooktop Knobs Installation Instructions - Manual (Page 5)

5
Installation Procedure
en-us
Installation Procedure
Installation Procedure Observe the following when installing:
▯ When installing the control knobs in the work surface,
seal the edges of the holes to make sure that they are
water-tight.
▯ Depending on the distance between the control
knobs, it may be necessary to break off the retaining
plate at the perforation.
▯ When installing an individual control knob, use two
screws to hold the retaining plate in place and prevent
it from rotating.
For stone countertops, use temperature-resistant two-
component adhesive (for metal to stone) to adhere the
retaining plate.
▯ Remove the protective film on the back of the
illuminated ring before installing.
▯ Ensure that the control knobs are allocated to the
correct burners during installation.
▯ The marking at the side to identify the control knobs
must always be on the left.
▯ The two cable connectors on the control knob are
identical.
▯ After installing, check that all plug connections fit
correctly.
▯ After installing all the cables, secure them to the
retaining plate by bending the tab down.
Follow the instructions in the manual for the type of
installation you require:
Installation on the front of the cabinet underneath the appliance
a ~ "Installation on the front of the cabinet
underneath the appliance" on page 5
b ~ "Installation in the countertop in front of
the appliance" on page 8
c ~ "Installation in the countertop next to the
appliance" on page 11
D