Wolf 15 Inch Transitional Induction Cooktop Installation Instructions - Manual (Page 10)

10 | Wolf Customer Care 800.222.7820
INSTALLATION
Cooktop Installation
Remove the cooktop and components from the shipping
package and recycle packing materials.
1 Lower the cooktop into the countertop cut-out. Center
the cooktop in the opening with the front edge aligned
parallel to the front edge of the countertop. Using a
pencil, outline the rear edge of the cooktop on the coun-
tertop. Remove the cooktop.
2 Apply the foam strip to the perimeter of the countertop
opening. Refer to the illustration below. Do not seal the
cooktop to the countertop.
3 Insert the cooktop into the opening. Verify the cooktop is
aligned with the front edge of the countertop.
4 Attach the brackets provided, to the bottom of the unit.
Insert the 3 1 /
2
" (89) clamping screws into the brackets.
Use a screwdriver to tighten the clamping screws
against the bottom of the countertop. Do not overtighten
screws. Refer to the illustration below.
Troubleshooting
IMPORTANT NOTE: If the cooktop does not operate prop-
erly, follow these troubleshooting steps:
• Verify electrical power is supplied to the cooktop.
• If the cooktop does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
cooktop. Wolf is not responsible for service required to
correct a faulty installation.
FOAM STRIP
COUNTERTOP
BRACKET CLAMPING
SCREW
Cooktop installation.