Echo HCA-2400 User Manual
Page 15
H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
15
A
SSEMBLY
(
HCA-2400,
SHC-2100, 2400)
SHC-1700 is Factory Assembled in the box.
GEAR
HOUSING
ASSEMBLY
/
DRIVE
SHAFT
(SHC-2400, HCA-2400)
Tools Required: 8mm x 10mm Open End Wrench, 4 mm Hex Wrench
Parts Required: Power Head/Drive Shaft Assembly and Gear Housing
Assembly.
NOTE
Hedge Clipper Blades are very sharp. Wear gloves to protect
hands.
1.
Slide the Gear Housing Assembly on the Drive Shaft. Be certain
the Flex Drive Shaft engages the hole in Driver Gear.
2.
Align the locating screw (A) with the locating hole (B) in the Drive
Shaft Housing, tighten screw (A) and clamping screws (C).
POWER
HEAD
/
DRIVE
SHAFT
(SHC-2400, HCA-2400 Only)
1.
Stand engine upright on a level surface.
2.
Loosen the two bolts at engine drive shaft end.
3.
Carefully fit drive shaft assembly to engine, making sure that inner
drive shaft engages into clutch mount.
NOTE
The arrow on the drive shaft housing must be in contact with the
engine (arrow on drive shaft indicates line).
4.
Rotate the drive shaft housing until arrows are centered with
engine bearing housing.
5.
Tighten bolts (A).
HCA-2400
SHC-2100, 2400
A