Epson V4.22 - Manual (Page 33)

32 An e-mail notifying the operator of a problem/warning/status is issued
If the projector experiences a problem or enters a status requiring attention,
an e-mail like that shown below is sent to the address specified for
"Recipient mail address".
If there is more than one problem, warning, or status, the corresponding
messages are output to separate lines.
The details contained in the e-mail message can consist of the following.
Messages to inform that the projector has recovered from the error or
warning statuses are sent.
Item Details shown
E-mail subject [Display name displayed in "Grouping view" or
"Detail list view"] Projector status notification
Body <Display name displayed in "Grouping view"
or "Detail list view"> has entered the following
status.
<Problem/warning/status message (Please see
the table below)>
Message Remedy
Internal Error See your User’s Guide for more information.
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power on
Lamp Error
High internal
temperature error
Low air flow error
Air filter air flow sensor
error
High-temperature
warning See your User’s Guide for more information.
Replace Lamp
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Clean Air Filter Notice
No signal No image signals are being received by the
projector. Check the connection status and
check that the power for the connected
equipment is turned on.
Other error
Supply System Error
(Ballast)
Auto Iris Error Stop using the projector, disconnect the
power cable from the electrical outlet, and
contact Epson.
Network error (TCP
connection error) Check that the projector's power is turned on
and the LAN cable is connected, and also
check that "Network Monitoring" is set to
"ON" or "Standby Mode" is set to "Network
ON".
Network error (ESC/
VP.net communication
error) Check that the projector has been correctly
connected to the network.
Network error (monitor
password authentication
error) Check the projector's Monitor Password.
Message Remedy