Electrolux ER 6642 T - Manual (Page 6)

6
Using the Appliance
Before Use
Remove all securing tapes.
Wash the inside of the appliance with lukewarm water
with a little bicarbonate of soda added (5 ml to 0,5 litre
of water). Do not use soap or detergent as the smell
may linger. Dry the appliance thoroughly.
Do not use detergents, abrasive powders,
highly perfumed cleaning products, wax
polishes or products containing alcohol.
F F
To Start the Appliance
1. Allow the appliance to stand for 2 hrs after
installation.
2. Plug in the appliance and switch on at the mains
supply.
3. Turn the thermostat control to the required setting.
A setting of 3 - 4 is usually suitable for normal
operation (see thermostat control).
4. Leave the appliance for approximately 4 hours for
the correct temperature to be reached before
placing food inside.
Thermostat Control
The thermostat control situated inside the refrigerator
regulates the temperature of the larder compartment.
Thermostat control is marked from 1-5 the higher the
number, the colder the setting.
Position 0 - Off
Position 1 - minimum coldness
Position 5 - maximum coldness
Model If the ambient Position of
temperature is drip tray
greater than
ER 6642 T +25 °C Open (pos. 1)
The temperature inside the refrigerator and the 2-star
compartment can be regulated further by adjusting
the tray located under the 2-star compartment.
To obtain a lower temperature in the 2-star
compartment when frozen food is stored inside and
when the ambient temperature is 25 °C or lower push
the tray in Position 2. When frozen food is not stored
in the 2-star compartment and when the ambient
temperature is higher than 25 °C pull the tray out to
Position 1.
If frozen food is stored in the 2-star compartment and
the ambient temperature is above 25 °C, pull the tray
out to position 1 and turn the thermostat control to a
colder setting (higher number). When the ambient
temperature falls below 25 °C turn the thermostat
control back to a medium setting and push the tray
into position 2.