EVGA Classified SR-2 - Manual (Page 28)

28
Connecting Internal Headers
Front Panel Header
The front panel header on this motherboard is used to connect the following
four cables.
(see Table 2 for pin definitions):
 PWRLED
Attach the front panel power LED
cable to these two pins of the connector.
The Power LED indicates the system’s
status. When the system is turn on status,
the LED is on. When the system is turned on, the LED will be on. When
the system is turned off or in S3 status, the LED will be off. When the
system is in S1 or S4 status, the LED will be on.
Some chassis do not have all four cables. Be sure to match the name on the
connectors to the corresponding pins.
 PWRSW
Attach the power button cable
from the case to these two pins.
Pressing the power button on the
front panel turns the system on
and off.
 HD_LED
Attach the hard disk drive
indicator LED cable to these two
pins. The HDD indicator LED
indicates the activity status of the
hard disks.
 RESET
Attach the Reset switch cable
from the front panel of the case
to these two pins. The system
restarts when the RESET switch is
pressed.
Table 2.Front Panel Header Pins
Pin Signal
HD_LED
1 HD_PWR
3 HD Active
PWRLED
2 PWR LED
4 STBY LED
RESET
5 Ground
7 RST BTN
PWRSW
6 PWR BTN
8 Ground
No Connect 9 +5V
Empty 10 Empty