Eiki WL-30(XG-705A) - Manual (Page 59)

59
8. Use the Moderator Function
Network Projector List
Exit moderator status
button
Moderator login
button
Set Session Password
button
Stop Remote
Capture button
Start Remote
Capture button
First, follow the procedure in “2. Setup Procedure”
➔ “Step 1–3” (p.16) and confirm that the
setting status is set as written below.
• Client application (NetworkModule Client) is installed on each client’s (except for the
moderator) computer and each client’s computer image can be projected.
• Moderator application (NetworkModule Moderator) is installed on the moderator’s
computer and moderator’s computer image can be projected.
Preparation Procedure for Using the Moderator Function
1. Configure the Moderator Login password in the projector to put the projector under
moderator’s control (p.51).
2. Resister a moderator in the projector with the moderator screen. Set the Session password
at this step. After the registration, only the moderator can control the projector and clients
cannot operate.
3. Each client registers to join the moderator’s group.
Now, Moderator function is set. The moderator and the clients can start the meeting with
Moderator function.
Client List
Preparation for Using the Moderator Function